We’re experiencing high demand for our services. It may take longer for us to respond than normal. Thank you for your patience.
Home
/
Help
/
Pyronix “Enforcer Time” / set the clock
Pyronix “Enforcer Time” / set the clock
After a power cut the keypad may flash Alert and show Enforcer Time until the date and time are set again.
Enter your user code (or present your tag) and read the message.
If it says Enforcer Time (or asks you to set the clock), use the master manager menu and choose Set date & time if you have the master code.
Set the correct date and time, then press Yes / confirm.
Press Yes to clear the Alert if it remains after the clock is set.
If you do not have the master code, or the message will not clear, contact us. See also fault lights and mains and battery faults .
These guides are general guidance
They are here to help with systems we install and look after. Makes, software and how a system was programmed can differ, so the steps may not match yours.
If you are not sure, stop and contact us . Do not work on alarms, cameras, lighting or electrics unless you are trained and comfortable to do so. These pages are not a substitute for a visit from a qualified engineer.
Our engineers do this work every day. We can quote for a visit if you would rather we did it.
Keiron Cheesbrough Ltd is not liable for loss, damage or injury from using these guides, except where the law does not allow us to exclude that.
Got a question?
Sometimes it's just easier to speak with a human...
Get in contact
© 2016–2026 Keiron Cheesbrough Ltd. All rights reserved.
Keiron Cheesbrough Ltd is a private limited company registered in England and Wales (company no. 11885860). Registered office: 97c Alexandra Road, Tipton, West Midlands, DY4 8TD, United Kingdom. VAT no. GB 318 9406 84. Tel 0121 295 1925 .